Astra GSi Forum

Roy 2.0 16v schreef:respect voor zn werk en die lading fotos

nou nog vertellen dat dit een astra gsi forum is, kadetten zijn om op te vreten en weer uit te schijten!!

Kadetten zijn dikke bakken! Jammer dat er steeds minder mooie exemplaren van zijn

ga maar is kijken hoe ze de kadett in engeland noemen...
ASTRA...

news

convey painted

it one repaints stung it of door I did not want !!!

antenna to remove these one of fakes that I to even support not on my car!!!

then the parchoc before it one thus not stopping the hole I I will make this week then I would bring back the parchoc for him

thus the car is to arrive has 12H

then veiled it has that places at the heat

vide sidérale

I have to start has to go up !!

the interior I is to require to them of steps to varnish it to me to avoid reflection

then all the scotche which A was to remove

then I have to start has to go up some fakes which to trail

bar of roof repaints in black matt

triangle side repaints in black matt

avant

après

cleaning of the joint of door

avant

après

by rear shock to go up!!!

with small the plastic bar is the joints

rod more joined to go up

beams to attach

thus I attack the front one

cutting

peinture

then disassembling of the wing !!puis peinture

then fixing of the wing with a small detail

then all to go up

the driving compartment I will even repaint it me because it have it trunk made

then I finished the day has to go up my bottoms of caisse!!faut that I to order the plastic clips

repaints in black subdue well on

then I have to look at or fix small the bombonej' atend to have the bucket to fix it as it is necessary!!

2nd that I would order thereafter I would fix it has the arch!!! like that

GrinX schreef:Merde, la vache kiri sil vout plait loge el trammelanto an die konto

scoff at origin (récaro) for my bucket seats

crémailler of direction not to assist

my news trape has gasoline

avant

après

moyeu de volant

sleeve sparco

my bucket

my wheels black mate....

I will assemble yoko parada into 205/40/16

Nice project.

--> Images are however not alowed in subscripts. <--

The seats look very nice!

nice

there are not much Kadett's left

for my car I have to start put to give those morning. I have varnish my compartment with the bomb of painting.

then I have accepted my hub theft protection device.

miss more than my wheel then I go up my instrument panel.

thus I have to decide to transfer my old alarm before going up my instrument panel.

I have to transfer dust to clean my connectic then gave of the Scotch tape has certain place.

then to stop the heating of the medium, it will be useful to me saw anything that there is my screen which comes in front of then I intend to assemble 3 mono in the place.

once to go up.

this week I will work on the completions

my bar anti rouli repaints.

if not I have to order that I wait until that arrives.

my new meter.

I finished all going up.

then I made pass the flexible device of the n2o, I have to cut out the arrear then in the week I fix my nx.

then I have to go up my system of essuis ice then I have repaints the matt mask in black.

good I received parts coming from expensive oréca

that allow me finalized my cockpit.

the surge tank of 1l.

for his price I find that it is super quality I will fix it at the place of my battery to the more meadows of the engine then I will manufacture itself all my connections BFG in hose connection stainless to braid

the double button will be for the n2o is the water injection
.

stealing oréca 330 of diam.

once to go up.

then my cut circuit I will place it.

if not I have to fix the fixing of N2o is I made discreetly pass the flexible device under my conducting seat.

I received my meter.

I will dismount it to repaint it gray party in black matt

the ren result well

miss more than has to connect it

I have to buy some parts to give has nine my direction then some kneecap expect from it my kit power-flex which I should receive in the week, with clignio of origin.

I have to connect my meter it walks niquelle…

then I have to assemble my station dvd more the option gps.

then I have to recover the pane of my meter lcd which I will modify to put my 4 mano black bottom.

in the week I will have fun has to assemble a button which I have to recover with breakage on a daewoo for the opening of my rear forage ladder.

then I have to remove lights it cigar I will put a button start engine at the place.

I have to as remove the ordi edge with the grid of heating misses more as 3 mano into 60.

then my led red to make believe that there is an alarm.
.

continuation

I received those morning, my order of expensive oréca

I thank raphael that I recommand, it am super cool.

complete kit power flex.

thus I have finally my lever b&m..

bouton start engine

I connect it in the week.

one even step of time is one attacks the assembly of the lever. : twisted:

thus I have to eclipse those which tien the lever of origin .puis to remove the lever of origin.